Strength & Balance Test Instructions
1st Determine the strength and balance of the person.
NOTE: In order to do these tests accurately please ensure that both the tester and the person being tested are not wearing or using any BIONIC products. If you are then BIONIC Energy will affect the test results and you will not get an accurate evaluation of the person. While testing please do not place any BIONIC products in contact with the person’s body, avoid drinking BIONIC Hydrogen Water for at least 4 hours before conducting tests, and do not consume food that has been placed on or near a BIONIC product.
Most of the day we are bombarded with radio waves, cell phone radiation and EMF waves. It is a controversial topic that constant exposure may result in health concerns. This type of stress on the body makes us weak and most people are not able to resist much pressure before going off balance, so there is no need to apply too much pressure.
TO TEST A PERSON’S CURRENT STATE OF BALANCE, FOLLOW THE THREE STEPS BELOW:
Â
|
|
|
|
|
|
|
|
|
STEP 1: Ask the person being tested to stand strong straight and tall with their hands by their sides and feet tight together. Make sure to ask the person being tested if they have any injuries that may be affected, example: bad back neck, shoulder or arm pain. If they do, you can test carefully using their strong side. |
STEP 2: Facing the person being tested, stand just to the left side of them so your right hand is in their right hand. For the left side your left hand will be in their left hand and you will stand just to the right of them. Place your closed fist in their cupped hand to make a ball joint. |
STEP 3:Â Â The tester will then simply lean into the person being tested and push straight down toward the floor, as shown in diagram 3. Not side-to-side or back to front, but straight down. If the balance of the person being tested is out of alignment, they will easily fall over. If not, they will remain strong, even with a great amount of applied pressure. |
Â
Â